Hyde Racing Swing Arm Protector Installation

1. Fit guard onto swing arm.
2. Align holes and insert all bolts loosely tightened.
3. Check fitment and tighten.

   **DO NOT over tighten bolts as this may damage the guard. Apply silicone to the base of the cap screw to stop the bolts from loosening.

    

4. Position zip tie just in front of axle. Tighten it over the guard and around the back of the swing arm.
5. Cut off excess zip tie.

**HINT-- Wrap the swing arm in duct tape before applying guard to prevent friction.

Questions? Call Jay @ 763-263-9835 or e-mail jay@hyderacing.com